Magnets, all the way down!

In many ways, magnets are still mysterious. They get their (often powerful) effects from the microscopic interactions of individual electrons, and from the interplay between their collective behavior at different scales. But if you can’t move these electrons around to study how factors like symmetry impact the larger-scale magnetic effects, what can you do instead?

It turns out that assemblies of metallic nanoparticles, which can be carefully arranged at multiple length scales, behave like bulk magnets and display intriguing, shape-dependent behavior. The effects, reported this week in the Journal of Applied Physics, from AIP Publishing, could help improve high-density information storage and spintronics technologies.

“The work was inspired by the question [of] how the magnetic interaction between nanoparticles influences the magnetic behavior of the system as a whole, since such array structures are used, for example, in high density storage media,” said Alexander Fabian, lead author of the study from Justus-Liebig University Giessen in Germany. “To study the influence of [the] shape of the nanoparticle assemblies, as well as the distance between them, we came up with the idea of a hierarchical design of the samples where the corresponding parameters can be varied systematically.”

The round, metallic Fe304 nanocomponents Fabian and his colleagues used in their study were arranged to form differing shapes at three different length scales. Using electron beam lithography, a modernized lithography method that uses electrons to write the desired structure, they configured the nanoparticles into closely-packed shapes, such as triangles, with one side measuring about 10 particles in length. A shaped grid of the smaller-scale configurations, spaced approximately one micron apart, comprised the third hierarchy of the length scales.

“For the preparation of the samples we used lithographic methods, which allow the precise control of the distance and the shape of the nanoparticle assemblies,” Fabian said. “For each of the three hierarchical levels, there are two contributions, namely the lattice-like part and the shape-like part. The high number of possibilities in sample design makes this a challenging aspect to find systems with the most promising physical properties.”

The shapes configured at each (sub-)scale were chosen based on their relative symmetries, so as to isolate the effects measured to their causal dimensional scale.

“The symmetries of the lattice and the shapes were here chosen to not interfere with each other. For example, the circular shaped assemblies were combined with different types of lattices,” Fabian said. “Assemblies of different shapes, such as triangles, squares or circles, exhibit an angle-dependence of the magnetic anisotropy (direction dependence) corresponding to the shape of the assembly.”

With these clever designs, the group was able to demonstrate a large-scale magnet, built from the nanoparticle up. Although their structures acted like bulk ferromagnets, the precise measurements surprised them.

“Our results show that on the chosen length scales, only the shape of the assemblies influences the magnetic behavior, revealing that the assemblies of nanoparticles behave like a single bulk ferromagnet.” Fabian said. “Most surprisingly was that the particles seem to behave like a bulk ferromagnet, but with a different magnetization value than that for bulk material, which is an interesting point for future investigations.”

Experiments like these can offer valuable, fundamental insight to the latest magnetics-dependent technologies, which make up much of the electronics market. But more fundamentally, these nanoscopically bottom-up approaches are demonstrating controllable means of probing the fundamental fibers comprising bulk and collective electromagnetic properties.

“From a fundamental point of view, it is very interesting to investigate nano systems like nanoparticles. Since they can be fabricated in a very controlled manner, they can also be studied in a systematic approach. Properties of the nanoparticles different from the bulk, or even new properties like superparamagnetism, in nanoparticles make them also interesting for fundamental research.”


AL-FRANCOEUR-MAGNETISM-3D-MASTER-768x1014 Magnets, all the way down!

“Electricity, Gravity, Magnetism & Singularity/Ed Gray Motors” by Al Francoeur

There are many examples throughout nature where mirrored symmetry appears at the micro level up to the size of galaxies. The division line is very similar to the neutral line or Bloch Wall of a magnet. This is the premise of much of the model that Al Francoeur has been working on in relation to explaining how he believes the Ed Gray power supply works.

CLICK HERE

 

 


Story Source:

Materials provided by American Institute of PhysicsNote: Content may be edited for style and length.

Journal Reference:

  1. Alexander Fabian, Matthias T. Elm, Detlev M. Hofmann and Peter J. Klar. Hierarchical structures of magnetic nanoparticles for controlling magnetic interactions on three different length scalesJournal of Applied Physics, June 2017 DOI: 10.1063/1.4984201
(Source: sciencedaily.com; June 14, 2017; http://bit.ly/2rrCfr8)

Poor Man’s Battery Swapper – RS Stafford

At last year’s conference, Peter Lindemann demonstrated a Bedini SSG energizer that produced a lot of mechanical work all weekend and the batteries stayed charged up!

It worked beautifully and was done with an automated circuit that rotates the batteries in a certain way but most people do not have the know-how to be able to build that circuit.

At this year’s conference, RS Stafford replicated this battery swapping method with circuit breaks and other common parts from his local hardware store. It’s inexpensive and very, very simple to build. This is the machine that ANYONE can make work if they just follow some simple wiring diagrams and RS’s instructions.

Let me explain the Split the Positive concept… lf I were to ask someone – even someone with a background in electronics or electricity if a light bulb would light up if it were placed between the positives of the batteries as shown to the left, they would say no.

Let’s say they are 1.5 volt AA batteries. The two in series makes 3 volts and the other single battery is 1.5 volts by itself. Well, 3 volts – 1.5 volts in opposition means there is still a voltage potential difference of 1.5 volts between the positives. A LED bulb for example will indeed light up because potential differences are what are important in electricity and NOT polarity.

Here’s an important thing to understand – while the bulb is lit up, the current from the two batteries in series is charging up battery #3. Therefore, if battery #3 is dead, it will charge up as the bulb is lit. When it is charged, it can move to the position of #1 or #1 batteries and one of the batteries #1 or #2 can be placed into the #3 position and it will get charged up while the bulb is lit. So you can see that by constantly rotating these batteries, you actually wind up with way more load powering capability than you would get if you just ran the bulb on a single battery until it’s dead and do that for the other two batteries.

John Bedini came up with this method years ago after studying the concepts in the famous Ed Gray motor, which had a similar process, but with much higher voltages. The above example has been known as Bedini’s 3 Battery system and very few people have ever understood the profound implications of it.

Now when you combine this concept with a highly efficient Bedini Energizer where you can recover a high percentage of what goes into the system in addition to getting some extra electricity from some generator coils that have very low drag, you have the keys to be able to produce mechanical or electrical work while making up for virtually all its own losses. That means you have a simple system that keeps itself charged up and you can create the battery swapping part of the system with parts from your local hardware store!

Our power grid is doomed to crash and you will be at a very strong advantage with what RS is teaching you here in this presentation.

Learn more: Poor Man’s Battery Swapper

 

High Voltage N-Machine (demo) ESTC 2017


N-Machine High Voltage N-Machine (demo) ESTC 2017

NOW AVAILABLE!

High Voltage N-Machine by Aaron Murakami

Presentation: HIGH VOLTAGE FARADAY GENERATOR will show you how to charge a capacitor higher than what a 12 volt battery needs to be charged. This is done by simply contacting the perimeter and shaft of a spinning neodymium iron boron magnet. Since Faraday, only ultra low voltage with high current has been obtained by the Faraday Generator, but you will see for the first time how to have usable voltage. Aaron has charged a capacitor to 14.8 volts with a 1.5 inch diameter spinning neodymium magnet that is only 1/4 of an inch thick at a speed of only 1-2000 RPM. This sets a world’s record in usable voltage from a Faraday Generator. You will also learn how to create AC from a Faraday Generator, which was proven by Peter Lindemann and Michael Knox back in the 80’s and 90’s. This is an added BONUS presentation, which was not originally planned. Watch demo below. Learn more: High Voltage N-Machine

 

Aaron Murakami has open sourced many gigabytes of his work in Energetic Forum for many years – that includes his work on the plasma ignition, the “Gray Tube”, the water fuel cell technology, the Ainslie inductive resistor circuits and others. He is also a founder of Energetic Forum and Energy Science Forum, which has a combined membership of over 130,000 and is the primary organizer for the Energy Science & Technology Conference. Aaron is committed to the development and distribution of highly disruptive information. He is a former health food store owner and has spearheaded many ventures. He is a consultant to several technology groups. His books include The Quantum Key and A Course in Mind Power. His invention of the world’s most efficient plasma ignition system that actually ignites water in an engine has been awarded a U.S. Patent.

We didn’t think there was anything we could do to stop chemtrails, till we tried this…

Some of you have asked us to show some video footage of how the orgonite we make clears chemtrails above our house, so we put together this little informal video just for you. This is us on our rooftop live from Morocco showing you how the orgonite assembly on our roof creates a clear patch of blue sky above our house when the rest of the sky is typically covered with clouds. -Hope and Tivon


Click here to get our Full FREE Orgone Energy Presentation!
http://ftwproject.com/orgone-technology-presentation-sign-up-youtube/

Panel Discussions from 2017 Energy Science and Technology Conference (Video)

Many have said the panel discussions are their favorite part of the conference because it gives an insight into the personal nature of the presenters.

2017 Energy Science & Technology Panel Discussion 1 Speakers:

Al Francoeur (Electricity, Gravity & Magnetism),

Yaro Stanchak (Bedini’s Zero Force Motor),

Aaron Murakami (Hacking The Aether; Depalma’s N-Machine),

James Robitaille Multiple Order Harmonics QEG Tuning),

Geoffrey Miller (The Newman Motor),

Jeff Moe (The Gold Magnet)

 

Panel Discussion 2 Speakers:

Susan Manewich (Alternative Energy Researcher/Writer/Speaker)

Jeane Manning (Alternative Energy Researcher/Writer/Speaker)

Walt Jenkins (H2 Global)

Dr. Paul LaViolette (Two Overunity Technologies)

Aaron Murakami (Hacking the Aether; The N-machine)

Prof. Robert Haralick (Mind Over Matter)

Paul Babcock (The Universal Medium)

This discussion concluded the 2017 Energy Science & Technology Conference and included topics such as Emotional Intelligence, Synchronicity, Remote Viewing, Creativity, the Subconscious Mind, the Collective Unconscious, and of course some discussion on Energy technologies. MUST SEE!

 

 

For A & P Electronics Digital Products
CLICK HERE

Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…

The following presentations from the 2017 Energy Science and Technology Conference are now available:

Poor Man’s Split the Positive Battery Swapper System by RS Stafford

POOR-MAN-3-BATTERY-COVER-3D-TEST-2-768x1014 Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…At last year’s conference, Peter Lindemann demonstrated a Bedini SSG energizer that produced a lot of mechanical work all weekend and the batteries stayed charged up!

It worked beautifully and was done with an automated circuit that rotates the batteries in a certain way but most people do not have the know-how to be able to build that circuit.

At this year’s conference, RS Stafford replicated this battery swapping method with circuit breaks and other common parts from his local hardware store. It’s inexpensive and very, very simple to build. This is the machine that ANYONE can make work if they just follow some simple wiring diagrams and RS’s instructions.

Released August 2017.  Learn more: Poor Man’s Battery Swapper

RS-Stafford Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…


MULTIPLE-ORDER-HARMONICS-3D-MASTER-768x1014 Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…Multiple Order Harmonics: Tuning the QEG by James Robitaille

Ronald Brandt was a brilliant experimenter who was successful in developing many Tesla and related technologies. He associated with many of the legends of the “Free Energy” and Tesla Sciences field including the late John Bedini who he shared his well-known “Tesla Switch” plans with that ran an electrical motor in a unique way that allowed the batteries to stay charged up while producing an abundance of mechanical work.

With a different methodology, he developed a generator technology that had high energy gains based on synchronizing various resonances in the system and this serves as the foundation for the Quantum Energy Generator or QEG project, which became an internationally known phenomena by Hope Girl and the Fix the World Organization.

Released August 2017. Learn more: Multiple Order Harmonics: Tuning the QEG

James-Robitaille-QEG Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…


h2global-3d-master-768x1014 Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…

H2 Global by Walt Jenkins

Most water fuel researchers and developers are focused on methods to separate hydrogen and oxygen from water with electrolysis (running electrical current through the water).

However, there are other ways that are much more efficient and effective. With only hundreds of miliamps, Walt Jenkins can run an engine with 95%+ water.

He isn’t using electrolysis, but he was heavily involved with that years ago and he is actually the original developer of the popular dry cell that most experimenters are using.

Although this presentation is not a full disclosure, he does share some concepts regarding this method that point people in the right direction. Keep in mind that this is the first time he has given a presentation to the public.

Released August 2017. Learn more: H2 Global

Walt-Jenkins-H2-Global Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…


AL-FRANCOEUR-MAGNETISM-3D-MASTER-768x1014 Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…

 

Electricity, Gravity, Magnetism & Singularity

If you’re a fan of Ed Gray’s technology, then this presentation is a must have. And if your not, you should be! It was one of the most profound demonstrations of Free Energy in history and we’ve never been this close to understanding the operating methodology.

ATTN: At the request of Al Francoeur, a portion of the proceeds and all royalties for this presentation will be donated to the local Salvation Army or Union Gospel Mission of Spokane, Washington to feed and shelter the homeless.

 

Released August 2017. Learn more: Electricity, Gravity, Magnetism & Singularity

Francouer Technical Presentations ESTC 2017: H2 Global, QEG, Poor Man’s Battery Swapper…